Metronic AccessBox Guia do Utilizador descarregar pdf (Página 12)

You can either add a particular channel if you know its parameters (frequency, polarity, SR),

or you add a new unknown channel (update).

Add channels from a transponder

A channel is transmitted by what we call a transponder. It is a relay satellite of which should

known the 4 following parameters:

• Its frequency (e.g. 12551 MHz).

• Its debit of symbol SR (e.g. 22000)

• Its polarity (e.g. Vertical)

• The satellite from which it is transmitted (e.g. Astra 28.2).

You will find these parameters in specialised magazines, which provide a monthly update, or

on dedicated websites (www.satcodx.com, www.lyngsat.com,…) To add channels from a

transponder, do the following steps:

• Go into MENU / INSTALLATION / CHANNEL SEARCH.

• On the line SATELLITE press OK to display the satellites list.

• With the CH keys, select the satellite, which emits the channel, to be added then press

OK.

• On the line SEARCH MODE, leave MANUAL.

• On the line FREQUENCY, type the 5 figures of the transponder frequency.

• On the line SYMBOL RATE, type the 5 digits of the symbol rate (SR);

• Check that the level is green, which means that you entered the correct parameters.

• On the line NETWORK SEARCH, if you choose ON the search may continue on other fre-

quencies if the operator broadcasts parameters of linked transponders. Let this field OFF.

• On the line FTA / SCRAMBLED, choose FTA to save space, by not putting in memory

scrambled channels that you can't watch.

• Press OK to launch the channel search. The window CHANNEL SEARCH lists the TV and

radios found.

The new channels will be added to the end of the channel list.

Automatic channel search

• Go into, in MENU / INSTALLATION / CHANNEL SEARCH

• On the line SATELLITE, press OK to display the satellites list.

• With the CH keys, select the satellite, which emits the channel to be added, then press

on OK.

• On the line SEARCH MODE, choose AUTO.

• On the line FTA / SCRAMBLED, choose FTA

• Press OK to launch the channel search. The window CHANNEL SEARCH appears and lists

the TV and radios found.

Note: in the AUTO search mode, the receiver will search channels from each trans-

ponder it has in memory for the concerned satellite. If a channel is not found, and

you are sure that it exists, it may be because you need to update the transponders

list. (see next paragraph)

Add / Delete / Edit a transponder

• Go into MENU / INSTALLATION / SAT/TRANSPONDER EDIT

• In the lefthand column, select the satellite with the CH keys.

• Press  to go to the righthand column and select the transponder to be edited or deleted.

• Press OK to show the action-selection window.

• To delete the transponder, choose DELETE TP, press OK and confirm YES. The entire trans-

ponder channel will be erased.

• To modify the transponder, choose EDIT TP and press OK to reach the edition window. Enter

the new values and press OK.

• To add a new transponder, choose ADD NEW TP and press OK to reach the edition window.

Enter the values and press OK.

ADDING CHANNELS

Ntc Accessbox-GB 3/11/03 8:44 Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comentários a estes Manuais

Sem comentários

Metronic AccessBox Guia do Utilizador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor Metronic AccessBox